By Edmonton Garage Door Services

11/29/2013 It is surprising to notice how many people prefer to choose expensive replacement instead of repairs. In case your garage door is causing trouble, you should look into repair as well. Most of the times, the companies prefer that customers buy a new door. If you happen to notice the issues concerning your old garage door, you will observe that a repair job will cost significantly less. Here are some tips from Edmonton garage door repair professionals that can help you do some DIY repairs.

DIY garage Door Repair Tips

As per Edmonton garage door repair professionals, the reasons for garage door malfunctioning can be myriad. Usually, the reasons may not be the ones you think. So, let's see the reasons and probable solutions to your garage door woes.

1. Poor Garage door Installation – This is an inherent problem right from the start. You will notice it the first time you open/close your door. The only solution to this problem is to ensure that the right professionals install your garage door. It must be installed with high precision by the right individuals. The slightest flaw can cause abrupt functioning or even complete breakdown. The garage door manufacturer instructions must be followed diligently.

2. Low Quality Products – with market today flooded with cheap garage doors, it is easy to be conned into buying a low quality garage door. Do some research before buying a garage door. Choose only high –quality garage doors from trusted brands. The Edmonton garage door repair professionals will offer you advice on the right door.

3. Roller and Rail – These are perhaps the most common cause of garage door breakdown. Your garage door might be infected with misaligned guide rails or bad rollers. This could occur due to improper guide rail installation or jerks during daily functioning. Also, jammed rollers can be cured by some lubrication. Use the right oil for lubrication as recommended by the manufacturer.

4. Opener Breakdown – garage door opener is the life and soul of the door. It helps lift the heavy door and close it as well. It works in tandem with the garage door springs. It consists of both mechanical as well as mechanical moving parts. So, a lot can go wrong here. Garage door openers usually suffer from poor installation, inadequate power, excessive usage and spring mismanagement. All of these problems must be looked into by a professional.

5. Dry Parts – Garage doors work through a watch-like coherent movement of many parts. Its working depends on the right moving action of all the mechanical parts. And all these parts require regular lubrication for smooth functioning. Make sure that you oil the important parts of your Edmonton garage door or it will jam.

6. Wiring Issues – There are electrical components in the garage doors that need to be handled carefully. The cable and wires can run their lifetime and need to be replaced. Know the ratings of the wires and electrical equipments installed.

7. Alignments – The tracks or the railings can be misaligned due to continuous operation. This will put load on the opener as well as cause the panels to bend/twist. Check the alignment of the railings and tracks for optimal operation. Original Source:- http://www.articlesbase.com/home-improvement-articles/garage-door-repair-edmonton-professionals-reveal-their-secret-tips-6737704.html